Продам KSR Juno - шикарный усилок в варианте 50 ватт, целиком сделанный в америке. 3 канала - один чистый и два с перегрузом. Довольно универсальный агрегат - может от прекрасного чистого звука до настоящего хайгейна.
В комплект входит футсвич, чехол, лампы JJ EL34 (шли вместе с усилком), КТ88 Genalex Gold Lion (сейчас стоят в нем). Внутри есть няшная подсветка, цвет настраивается на задней панели;
Только домашнее использование, без косяков по внешке
Будут вопросы - пишите, на все отвечу
Цена - 120 000, усилок в СПб
Вот описание с сайта производителя
Summary
The Juno™ amplifier is our first amp designed specifically around EL34s. It is a British inspired 3-channel modern hot-rod capable of a huge array of tones from clean, to ultra-tight percussive rhythms, to smooth thick leads.
Channel Descriptions
Each of the three channels has a Gain, Bass, Mid, Treble, Level control, and Bright switch. The dirty channels have a 3-position gain mode switch and Feel knob for fine-tuning the overdrive tones and low-end / mid-range response.
Clean Channel
This channel produces a wonderfully warm tone that aims to be the best of any channel switching amplifier. Where most other high gains amps seem to include a clean channel out of necessity rather than desire, the Juno™ has a no-compromises clean channel with its own dedicated preamp tube voiced specifically for huge headroom and sparkling cleans. With the included Gain control on the clean channel, one can also dial in a very cool vintage style distortion.
Dirty Channels
The dual Juno™ gain channels are essentially identical and can be setup the same, or completely different. The Crunch and Lead overdrive is based on the signature high-gain sounds of the Orthos™, but modified in a way reminiscent of the classic 80s hot-rodded amps. A 3-way gain mode switch provides Crunch, Lead, and Clip modes for three very different types of distortion.
Master Section
The Juno™ features the same proven transparent and wonderfully performing effects loop as our other amps. The loop circuit is true-bypassable via the front panel Loop assignment switches, as well as a rear panel 1/4″ contact closure jack. In addition, the loop has independent Send and Return Level controls for maximum flexibility.
The master section also includes power amp response controls, Top and Bottom. The Top control affects the response of the power section to treble frequencies, whereas the Bottom control affects the bass frequencies. These controls are great for dialing in the amp’s response to different speaker cabinets. They also allow the player to optimize the amp for different master levels. It’s especially useful for adding awesome bottom-end and clarity at low volumes.
The power section consists of a quad of TAD EL34 tubes, standard. However, just about any octal power tube can be installed — 6L6GC, KT88, KT77, etc. Each tube is individually fused in order to protect the amplifier in the event of a tube failure. A Fault LED lights to indicate a fuse has blown and the tube is no longer functioning. One can also remove a pair of tubes as an easy way to run the amp at half-power.
A custom wound USA made output transformer with a lower primary impedance turns this amp into an angry beast, and is one of the highlights of this amplifier. Parallel speaker outputs allow one to easily drive two cabinets with a total impedance of 4/8/16 ohms.
Another one of the unique features of this amplifier is its universal power input. This allows easy use by any player around the world and eliminates the need for power converters or transformer swaps for shipment to any international country.
Размещение рекламы