Добрый день,
Подскажите, как на одну из кнопок футсвича 5150 повесить функцию одновременного включения второго канала и петли?
Хочу заказать футсвич в voodooswitches, но пока с месяц с деньгами напряжно будет, хочу родной доработать.
Там мне ответитли, что такое возможно, есстесственно без описания тех. подробностей:
Yes, it is possible to create both versions of what you want with LED's.
Button 1 = CHANNEL
Button 2 = LOOP
Button 3 = BOTH
For the 3 button version to operate amp would have to be on channel one and
the
loop would have to be off, then the third button could switch both the
channel and
loop simultaneously. Button three would then need to be off to have
independent
operation of the channel and loop functions again.
If you were on channel two and pressed button three it would just kick in
the loop
and have no effect on channel operation since the amp is already on channel
two.
If the amp was on channel two and the loop is on then button three would
have no
effect at all.
While you have button three on you could change the status of button one and
button
two. Say you want to have either the loop or channel two still engaged after
you turn
off button three just step on the channel or loop button and then disengage
button 3.
Button 1 = CHANNEL
Button 2 = LOOP
The two button version would act in the same manner in that the amp would
have
to be on channel one and then button two would engage the loop and channel
two.
Unfortunately, you will not have independent control of the loop with this
version.
Размещение рекламы