This page has links to all of the
help pages for the GT-100 FloorBoard Editor, which
was made for conveniently editing internal settings in the Boss GT-100 Guitar Amp/Effects
on most common computers.
To have the best possible experience
using the GT-100 FloorBoard Editor with the Boss
GT-100 Guitar Amp/Effects unit, you should have a guitar and amp either already
set up and configured with the GT-100 or at least ready to configure in the
GT-100. You will also need to have a MIDI connection between the computer and
the GT-100, either via built in GT-100 USB with USB drivers installed or
standard MIDI device. You should also be familiar with what a patch is in respect to the GT-100. There
are links below to help you if you need more information on configuration and
an explanation of what information is contained in a GT-100 patch.
Using the GT-100 requires proper
setup of the GT-100 input level and tone parameters. For now, this
documentation assumes you have already performed configuration with the help of
the owner's manual. It may be added to this set of documents in the
future.
For more information on configuration, visit the VG forum GT-100 area
topic GT-100 Reference Library.
NOTE:
The following sections describe "global" parameters affecting all
GT-100 patches. When you make a change to these parameters in the editor
or in the GT-100, it is automatically written to the GT-100. Also very
important to know is that any settings made in the SYSTEM, MASTER, or
PDL/GK configuration will take precedence over conflicting patch level Assigns
settings: