Я ставить не буду, но думаю, что кого-то это порадует:
https://line6.com/support/page/kb/effects-controllers/helix/helixhx-292-release-notes-r942/Bug Fixes in 2.92
When Global Settings > Footswitches > Stomp Select is set to "Off" or "Press," touch-holding switches could still result in assignment and swap dialogs—FIXED
The TAP LED in Helix Floor, Rack/Control, and LT could flash slightly slower than the actual tempo—FIXED
In HX Effects' Command Center, Hotkey commands could display values for HX Preset commands—FIXED
In HX Effects' Command Center, assigning a hold-type HX command could sometimes not engage properly—FIXED
Engaging the MODE switch while Global Settings were visible could result in unexpected behavior—FIXED
Engaging the MODE switch after selecting a different model during a bank queue could result in unexpected behavior—FIXED
In rare cases, bypass and parameter changes made from Helix Floor, Rack, or LT may not be reflected in HX Edit—FIXED
On Helix Floor and Helix Control's 1 Switch Looper scribble strip, Undo or Redo text could appear—FIXED
In HX Effects' Command Center, adding an HX hold-type command could result in an inverted switch state—FIXED
In HX Effects' Command Center, adding an HX Snapshot command could result in the wrong LED color—FIXED
In HX Effects' Command Center, engaging a HX Looper > 1/2 Speed or Full speed command could sometimes cause a lockup—FIXED
In rare cases on Helix Floor, Rack, or LT, renaming a snapshot could result in a preset change—FIXED
The polarity of some amp models was reversed in 2.91—FIXED
Dynamics > Rochester Comp could exhibit audible phase cancellation when its Mix parameter is set to 100%—FIXED
Dynamics > Rochester Comp now behaves as expected when the Ratio is set lower than 3:1—FIXED
In rare cases, scrolling quickly through the model list in HX Edit could cause the hardware to stop responding—FIXED
The Looper > 1 Switch Looper LED states would not function properly when controlled via incoming MIDI CCs—FIXED
Known Issues in 2.92
A slight thump can be heard when loading a Distortion > Kinky Boost, Arbitrator Fuzz, or Tycoctavia Fuzz model
While backing up, the scribble strip on FS8 can sometimes flicker (Helix Floor, Helix Rack/Control)
In very rare cases, leaving the unit on for many hours can sometimes cause reverb models to cease outputting audio
In a preset with two IRs blocks, moving one IR block to Path B can sometimes cause the other IR block to reset its Impulse Response to slot 1
In rare cases, after exporting and then importing presets using HX Edit, the Split block's bypass state can sometimes change (Helix Floor, Helix Rack/Control, Helix LT)
When using Blue Cat Audio's PatchWork VST host software, resizing the Helix Native window may not scale smoothly (Helix Native)
Размещение рекламы